Check out the new Tape Project website at tapeproject.com, now with online ordering. Inventory is updated every week, so stop by often to see what we have in stock.

Author Topic: Jumper wire ?missing? MX5050 BII 2  (Read 4650 times)

Offline ed

  • Jr. Member
  • **
  • Posts: 18
    • View Profile
Jumper wire ?missing? MX5050 BII 2
« on: February 10, 2012, 12:25:03 AM »
While switching speed modes, cleaning, etc. etc. (it never really stops, does it?) I noticed there is a jumper wire (WHITE in pic) on the pcb above the supply reel motor and NOT one on the take-up motors pcb. Jumper goes from "Line" to "117V" (choices of 100, 117, 220 & 240 volt). Is this correct??
Thank you,

ed

Offline Listens2tubes

  • Sr. Member
  • ****
  • Posts: 284
  • Reel Analog
    • View Profile
    • Listens2tubes
Re: Jumper wire ?missing? MX5050 BII 2
« Reply #1 on: February 11, 2012, 02:40:46 PM »
Yes. At least that's how my machines are wired.
Neal - Ampex Fineline F-44, 3 - Otari MX5050BII-2, Revox A77 Mk II , Teac A 4010s, 4070, Sony TC102A, Magnecord 1020, Systemdek IIX/Dynavector Karat 17D2MKII, CEC CD3300 CDP, K Works NanoMax DAC, Van Alsine Transcendence Eight+ tube preamp, Dynaco MkIV amp pair, Paradigm Reference Studio 100 v1