46
Tape Project Albums - general / Re: What's the ETA on the Series 3 titles announcement?
« on: August 23, 2010, 01:23:54 PM »
That's a pretty good question, I'd like to know when also so I can get my funding ready.
Jay
Jay
TP-027, Jerry Garcia / David Grisman wins a Writer's Choice Award from Myles Astor of Positive Feedback Online
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
it's late and i'm tired. i had 25 people in my room tonight for an audio club meeting, and a few stayed till after 11pm.Yea Mike,
we played about 40% RTR tape. the 2 tracks we played from 'Rock With Me Baby' stand out as the best of the best of the tapes we played. holographic, vivid, alive, compelling. i like the music. alot. but even if you only 'sorta' like the music this one will grab you.
is this the best tape yet? it might be.
when i recover from my 'event' i will listen all the way thru and expand on these comments.
Steve,Hi Guys,
What would cause uneven packing of the tape when rewinding it to play? After rewinding one of my TP tapes earlier today the packing was all uneven, and I had a hard time getting it back to a nice tidy pack.
No problems with any other tapes I played today on the same deck.
Jay
Can static electricity/room humidity have anything to do with variable results?
I did try cleaning it with Progold but it didnt help much. I suppose I need something more abrasive. Well, at least I knw that the tube rush sound that I have been hearing is due to TFK ef 806s that I have been using. I suppose it better to buy from more reliable seller but it wouldnt be cheap.Song,
Will be comparing my amperex 7308 PQ with telefunken e88cc and e188cc and lets see how it goes
Refering to a schematic of the unit (or looking inside at the record amp circuit boards), find the record level calibration pots and connect the pot output (the wiper) to your output jacks. This signal will be post fader and post para EQ. If there is no audio signal on the pot, then there is a mute transistor (or FET) prior to that pot that needs to be disconnected. Refer to the schematic for that.