Can you believe it? Tape Project is ten years old! Thanks to everyone who has supported us in introducing studio quality tape reproduction to the audiophile community!

Author Topic: How to Align Otari MX 5050 BII  (Read 6714 times)

Offline jcmusic

  • Sr. Member
  • ****
  • Posts: 345
    • View Profile
How to Align Otari MX 5050 BII
« on: July 18, 2018, 06:38:39 AM »
My question is how do I go about aligning my deck while having the direct head wiring out to my tape pre? Since I have the deck setup this way I have lost the meter functions, so I need advice on how to align???
Redpoint Model D TT/Soundsmith Sotto Voce Cartridge Otari MX 5050 BII/BH Tube Repro deHavilland Model 222
 Ah Njoe Tjoeb 4000, Rogue Magnum 99, Korneff 45 SET Amp, Klipsch K-Horns Bass Bins/2" Tractrix Horns 2" BMS Drivers, Vintage Tubes.

Offline docb

  • Administrator
  • leader in spreading disinformation
  • *****
  • Posts: 1345
    • View Profile
    • Bottlehead Corp.
Re: How to Align Otari MX 5050 BII
« Reply #1 on: August 20, 2018, 01:42:19 PM »
A scope with an X-Y display is the best way to align a head, using a Lissajous figure. It's much easier and more precise than using the VU meters.
Dan "Doc B." Schmalle
President for Life, Bottlehead Corp.
Managing Director - retired, The Tape Project