Tape Project Forum

Tape Machines => Tape Project Machines => Topic started by: tfrei on December 12, 2015, 04:07:52 AM

Title: bypassing preamp on otari mx 5050
Post by: tfrei on December 12, 2015, 04:07:52 AM
Hi.  I'm new to this forum.  I'm looking all over for some guides on bypassing the otari mx 5050 internal (stock) preamp.  I've done various searches on this forum, but I don't see any specific guides.  IF there is one, could we put it as a "sticky" in this section of the forum.  This section would be the obvious first place to go for this type of information, I think.

posted by Tom Frei, a newbie who just bought a Otari mx 5050.
Title: Re: bypassing preamp on otari mx 5050
Post by: docb on December 13, 2015, 11:40:01 AM
Shawn Phelps did the original MX-5050 mod at Bottlehead. I'll ask him if maybe he can take a pic or two of his deck showing which cables you need to move.
Title: Re: bypassing preamp on otari mx 5050
Post by: tfrei on December 14, 2015, 02:15:57 AM
Thank you.  That is probably the same Shawn Phelps who is building my new eros tape head (once he gets the kit).  I think I'm also going to look for a manual.  Am I right that there are two manuals: a user manual and a service manual?

Title: Re: bypassing preamp on otari mx 5050
Post by: ironbut on December 14, 2015, 01:30:25 PM
Hey tom,
 
Welcome to the forum.
There are a number of manuals and schematic packs for the Otari.
You should be able to download them all (including some you don't need) from a link located in our "Links" sticky.
That sticky is located above the General forum.
The post that contains the links in #19.
Be sure and save those manuals. They were missing in action and a member here was kind enough to bring them together and make them available.