TP-028, Nat Adderley's Work Song is now available

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - argibbo

Pages: [1]
1
Reel to Reel Tape Machines / Studer A80VU sync output
« on: March 07, 2014, 09:22:02 AM »
Hi
I have a Studer A80VU, quarter inch half track. I'm keen to use the sync output(s) for overdubbing and trying the ADT/tape phase thing. Sync outputs separately connected to patchbay. Record and replay sockets working fine. No output on Sync. Do I need to be in a certain mode? I have adjusted the sync output level to no effect. Has anyone any ideas? Maybe the sync output is disabled on two channel machines?
Any help much appreciated
Cheers
Andy

2
Reel to Reel Tape Machines / Technics RS1506 Reel Table or motor assy
« on: March 07, 2014, 09:17:56 AM »
Hi
My Technics 1506 works fine however the left hand hub is broken, though still usable. I don't think the reel table can be replaced on it's own? Has anyone got a spare, either motor/brake assy or reel table to sell?
Cheers
Andy

3
Reel to Reel Tape Machines / Re: technics rs-1500 maintenance help
« on: March 07, 2014, 09:14:50 AM »
Hi Everyone
I too have a Technics RS15-6, plus the additional 4442 headblock. I had a problem with mine. The top end began to disappear on playback after a few moments. It turned out that the tape tension was not being maintained over the headblock. The cure was to check and adjust the yoke that applies the pinch rollers to the capstan, and then to check capstan pressure. Both rollers must touch the capstan at the same time. All this is available in the service manual. Properly adjusted the tape runs perfectly.
Cheers
Andy

Pages: [1]