TP-027, Jerry Garcia / David Grisman wins a Writer's Choice Award from Myles Astor of Positive Feedback Online

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mrush

Pages: [1]
1
Tape Project Albums - general / Re: Series Three Updates?
« on: January 23, 2015, 08:09:49 PM »
I hope I'm one of the 8.

2
Tape Tech / Re: STUDER A810's initialzation problem.
« on: June 02, 2011, 10:49:51 PM »
Hi YJ:

Sounds like you are making good progress on your 810.

Try holding the stop button when you press the CCIR/NAB and Mono/Stereo buttons.  There is a dip switch on the Periphery Control board that enables the calibration mode.

The caps are definitely a problem. My 810 was built around 1987 and all the blue Philips caps are bad.  I haven't had any short yet but they all measure around 50% to 75% of the capacitance.  A few have been open.  I started with the power supply and audio boards and haven't gotten to the Basis (mother) board yet.  It's the one all the other boards plug into.

I have tried spinning the guide roller and the counter never seems to move.   It always works with tape.  Can you run any tape yet?

Thanks,
Mac

3
Tape Tech / Re: Maxell UD 35-90
« on: April 07, 2010, 11:33:08 PM »
I have some Scotch 203 from the 60's, some Scotch 207, BASF, and Maxell UD and UD-XL from the 70's and 80's.  So far I haven't had any problems.

Mac Rush

Pages: [1]