Tape Project Forum

Tape Machines => Reel to Reel Tape Machines => Topic started by: eta535 on October 20, 2010, 02:21:44 PM

Title: OTARI MX 50 Voltage change
Post by: eta535 on October 20, 2010, 02:21:44 PM
Hi,
Does anybody knows, what is the right configuration of the Voltage change pins of the MX 50. I'd like to change the voltage from 117V to 240V. But there is no figure of it in the Owner's manual, like It's shown in the manual of 5050 BIII. But it's not the same as the MX 50.
Thanks
Title: Re: OTARI MX 50 Voltage change
Post by: eugen_syd on October 31, 2010, 05:34:03 PM
I have an MX50 which I pulled down for parts. I'll have a look and send you some pics to assist you. Send me an e-mail if still needed.
Regards,
Eugen