Tape Project Forum

Tape Machines => Reel to Reel Tape Machines => Topic started by: Rwsteiner62 on April 10, 2013, 10:28:06 AM

Title: Teac A-4010sl power supply
Post by: Rwsteiner62 on April 10, 2013, 10:28:06 AM

Hello, I'm new to the forum and 1st time reel to reel owner. I inherited a project started and left hangin'. there are 3 wires hanging from #2,#6 and#8 points on the power supply board ,and a twisted pair of blk/white wires leading toward the transformer. just below the board are 2 elec caps 1- 100uf @160v and 1-1000uf @35v . Which wires go to each of theses caps. Thanks....Rob

Title: Re: Teac A-4010sl power supply
Post by: ironbut on April 10, 2013, 12:29:12 PM

Hey Rob,

You should download a service manual.

http://www.hifiengine.com/library.shtml

Title: Re: Teac A-4010sl power supply
Post by: Rwsteiner62 on April 10, 2013, 01:19:41 PM

Thanks ,have it, can't make heads or tails of the schematics

Title: Re: Teac A-4010sl power supply Bridge rect
Post by: Rwsteiner62 on April 12, 2013, 09:42:01 AM

Sorted the wiring. Need to replace nte116 silicone diode, Going to use 1n4007. As far as the bridge rectifier, they call it a silicone stack sib 02 - b-01, I'm guessing to use 600v 2a bridge rect