Tape Project Forum

Tape Machines => Tape Tech => Topic started by: mstcraig on January 16, 2008, 03:51:13 PM

Title: Bottlehead Seduction question
Post by: mstcraig on January 16, 2008, 03:51:13 PM

This is directed at Doc, mostly. With the above, is it possible to modify in such a way to have both NAB or IEC tape EQ switchable? From what I see, it appears it is assembled as one or the other EQ. Some clarification would help. Can this be done? I can't afford your more expensive preamp that already has this feature built in. Thanks!

Title: Re: Bottlehead Seduction question
Post by: AZ_Gary on January 16, 2008, 06:26:20 PM

I'm not Doc, but I have done it. Piece of cake. Just use two toggle switches.

Gary

Title: Re: Bottlehead Seduction question
Post by: ironbut on January 16, 2008, 06:54:06 PM

Gary's right. If I can do it easily, anyone can. I think the hardest part was deciding where to put the switches. Here's a link to the instructions. It's at the very bottom of the page.
http://www.bottlehead.com/et/adobespc/Seduction/bottleheadtapeheadpreamp.htm (http://www.bottlehead.com/et/adobespc/Seduction/bottleheadtapeheadpreamp.htm)