1
Tape Tech / Re: A810 faults
« on: June 26, 2012, 01:49:44 PM »
OK, I ask very simple question: how to program tape lifter able/disable functions? By jumpers, code switch or program keys?
Thank you
Thank you
Check out the new Tape Project website at tapeproject.com, now with online ordering. Inventory is updated every week, so stop by often to see what we have in stock.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Tape Tech / A810 faults
« on: June 25, 2012, 05:02:21 AM »
hi, everybody. I purchased the A810 machine recently and run into two problems:
1. in FF and Rewind modes transport suddenly comes to stop after 10 - 20 sec after one of < > keys was pressed and LED display reads 0188. It happens only when 1 mil tape on 10 inch reel is loaded. If the tape is 1,5 mil on 10" reel or 1 mil tape on 7" reel loaded FF & REW modes are OK.
2. Lifter activates only in FF & REW modes, but not in STOP mode so the tape contacts the heads. Ii it possible to solve the problems? I'll be very appreciate your help.
I went through SM twice but didn't find any useful information.
Regards, Nikolay
1. in FF and Rewind modes transport suddenly comes to stop after 10 - 20 sec after one of < > keys was pressed and LED display reads 0188. It happens only when 1 mil tape on 10 inch reel is loaded. If the tape is 1,5 mil on 10" reel or 1 mil tape on 7" reel loaded FF & REW modes are OK.
2. Lifter activates only in FF & REW modes, but not in STOP mode so the tape contacts the heads. Ii it possible to solve the problems? I'll be very appreciate your help.
I went through SM twice but didn't find any useful information.
Regards, Nikolay
Pages: [1]